--- title: '`glab config path`' stage: AI Clients group: Developer Clients info: To determine the technical writer assigned to the Stage/Group associated with this page, see --- Print the location of the global configuration file. ## Synopsis Print where `glab` reads and writes its global configuration. The location depends on the platform and whether a legacy configuration directory exists, so use this command instead of hard-coding a path. The command prints the path even if the file does not exist yet, so it is safe to run before the first `glab auth login`. Use `--dir` to print the parent directory. Grant write access to that directory rather than to `config.yml` alone, because `glab` writes a temporary file in that directory first and then replaces `config.yml` with it. Repository-local settings live in the repository's `.git/glab-cli/config.yml` and this command does not report them. If no user configuration file exists, `glab` falls back to a read-only system-wide one. This command always reports the user location. Your own configuration file must not be readable by anyone else, so it needs mode `600`. A system-wide one, in a directory listed in `XDG_CONFIG_DIRS`, is read whatever its read permissions, but is refused if it is writable by group or others. ```plaintext glab config path [flags] ``` ## Examples ```console # Print the path to the global configuration file glab config path # Print the directory that holds the configuration file glab config path --dir # Open the configuration file in an editor $EDITOR "$(glab config path)" ``` ## Environment variables ```plaintext GLAB_CONFIG_DIR: Set to a directory path to override the global configuration location. ``` ## Options ```plaintext --dir Print the configuration directory instead of the configuration file. ``` ## Options inherited from parent commands ```plaintext -h, --help Show help for this command. ```